• Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • Powerleveling Pets Guide

    Discussion in 'Honorbuddy Forum' started by aleksiy, May 17, 2013.

    1. aleksiy

      aleksiy New Member

      Joined:
      May 17, 2013
      Messages:
      5
      Likes Received:
      0
      Trophy Points:
      0
      Based on this video:
      Should also show you how to get your first 25.
      The Fastest Way to Powerlevel Your Pets

      What you need:
      -two level 25 pets
      will be fighting 3*23 pets mix of aquatic critter and air
      -Pokebuddy plugin
      http://www.thebuddyforum.com/honorb...81355-plugin-pok-buddy-gotto-kill-em-all.html
      -Profile
      View attachment dragonblightpets.xml

      Configuration:
      Alright before you get to botting you need setup everything correctly.

      1. First things first equip your pet that you want to level in the first pet slot. Then put your other two 25 pets in the others.

      2. Enable pokebuddy in your plugins then open its config. The General settings can all be left as default.

      3. Hit the Pet Logic Settings tab. On the right side, below Refresh Pet select Pet 1. Hit refresh pet. Now copy my logic and remember to hit save.
      Capture.PNG

      What this will do will make the pet hit the target and then swap when the target is below 100% health.
      If your pet has a shield ability. Change the logic to activate the shield and swap when the ability is on cooldown.

      Configure your other two pets as you think will work most efficiently.

      4. Select the Advanced Settings tab. Use the sliders to copy my values.**
      factorconfig.PNG

      **note: The idea of these values is to always have your lowest level come out first. This is not the most optimal way of doing this but the only one I could find at the moment. Perhaps someone will write a plugin sooner or later. Sometimes it does cause problems but for the most part it works. It does prevent from being able to use one 25 pet to level two low levels. If anyone has any ideas on how to tweak these for the better please post any improvements.


      5. Next you can close pokebuddy. Set your Botbase to Gatherbuddy 2.0. Turn of herb and mining. Load up the profile and fly to the spot.
      map.jpg



      Hit start.

      ***note: As this sits in one spot I recommend not running for too long and with breaks.

      Hopefully I didn't miss anything, will try to address any problems.
       
      Last edited: May 17, 2013
    2. Momosixtynine

      Momosixtynine New Member

      Joined:
      Apr 10, 2013
      Messages:
      38
      Likes Received:
      0
      Trophy Points:
      0
      Thanks for video :cool: I'll test this tomorrow
       

    Share This Page