• Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • HB ARCHIVES: Kick's Old Posts Thread--DO NOT DELETE!

    Discussion in 'Archives' started by fhlhwow, Aug 17, 2010.

    Thread Status:
    Not open for further replies.
    1. leonel916

      leonel916 New Member

      Joined:
      Jun 22, 2012
      Messages:
      32
      Likes Received:
      0
      Trophy Points:
      0
      It stand in one place.. Idk why for hours. I fresh install. It still does it. All it did was fly to a secific spot and stand there.
      heres a log
      Log - Pastebin.com
       
    2. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      Run [Rep] Daily Grind [Brodie].xml, it starts at Tillers and runs thru all the profiles.

      That is because Crumbling Halls and Thunder Below are not supported.

      Due to high respawns, dense mob collections, and the bot's inability to understand "flee from battle" at a specific time (i can not program my profile to supercede the CC, CC will always take over in combat), once you are in battle here, you must be out of battle for a good 3-5 seconds before the profile takes over from the CC.

      Do you have a log of this part happening? The bot will attempt to take quests (up to 4) from these NPCs. If the NPC has more than 4, it won't pick up that 5th, just based on how the code is written. If it makes a second pass, it should pick it up, but if the 5th quest is still in there (complete or not) it can throw this into a loop. This can happen if your quest givers have the Challenger's Ring quest, sometimes. Since these quests are 1 time at rep intervals, you can simply pick them all up manually, then run the bot. Until rep checks are fixed in HB, I can't code it to look for this quest specifically before the loop.

      Update your Quest Behaviors. v525 of HB overwrites the QB MrFishIt.cs. You must update it with the one from my SVN.
       
    3. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      Not sure why it got stuck there, but with a start/stop it fixed...could be an isolated incident. If it happens again, let me know, I'll look into it.

      Also, thatnks for the extra hotspots, they'll be in r611.
       
    4. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      I'm trying to get past the need for the minor babysitting. Every day, every update, we're getting closer.
       
    5. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      For these ones it could work good, maybe even the "fish in a barrel" one, but not the third, that goes super deep for mobs...CTM nav pathing is required there...and that's annoying. Although I think I can remove the constant resurfacing now. AntiDrown is working good, and most times you get a "waterbreathing" buff.

      EDIT:: Oh wait this is the super deep one isnt it...wow. If that works for this one, they should all. Yay!
       
      Last edited: Jan 14, 2013
    6. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      Trying my/our hardest. Any little things that the bot does that are blatantly bad though, let me know. Some things are intended, some are not. The more I fix, the better it runs!
       
    7. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      You didn't answer my questions...Specifics help...

      However, I did notice a huge error on my part...!Me.Mounted, should be !Me.IsMounted...
      This was preventing the bot from remounting if too close to the next waypoint, which would cause it to throw a "no path to location" error.

      This might fix your problem, if you were unmounted at the "location" you were stuck at.
       
    8. fpsware

      fpsware Community Developer

      Joined:
      Jan 15, 2010
      Messages:
      5,287
      Likes Received:
      133
      Trophy Points:
      63
      Due to the inclusions of the Shield Wall dailies and HB's mesh issues in this area this profile is no longer afkable.

      Until the area is meshed properly can you please remove the Shield Wall dailies?

      EDIT: While it didn't get stuck today, yesterday this saw my characters (4 of them) getting stuck for over 4 hours and receiving numerous whispers as a result.
       
      Last edited: Jan 14, 2013
    9. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      Understandable. Yes it will get pushed thru tonight.

      On a more awesome note, I fixed PerformTradeskillOn.cs CustomBehavior, and will be sending it thru on my SVN within the hour! Cooking now works! (I hope, it worked the first 5 attempts, lets hope for 6)

      EDIT: The portals are in r618
       
      Last edited: Jan 14, 2013
    10. maxi155

      maxi155 New Member

      Joined:
      Mar 8, 2012
      Messages:
      19
      Likes Received:
      0
      Trophy Points:
      0
      exploiting the situation

      hey, i have a problem with 5-12 durotar profile. buddy tries to pick up quest "exploiting the situation" but the q aint there. checked with old and new hbfolder and on 2 different accounts (each using own hbfolder).
       

      Attached Files:

    11. Madcatz

      Madcatz Member

      Joined:
      May 17, 2011
      Messages:
      752
      Likes Received:
      7
      Trophy Points:
      18
      yeah did that allrdy still no luck on it doing the quest im trying a new install its working fine ill go with that ty
       
    12. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      Which quest? What is it doing? Do you have an additional (newer) log?

      Also, if you do a fresh install, make sure you are re-adding the quest behaviors. v525 does NOT have the correct MrFishIt, and you MUST update it.
       
    13. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      r613

      Added
      -- PerformTradeskillOn.cs -- Replace existing
      Cloud Serpent
      -- Feast of the Senses - updated logic, and performing. Should now work for all clients, and
      ----only fish and make as many items as needed.
       
    14. Madcatz

      Madcatz Member

      Joined:
      May 17, 2011
      Messages:
      752
      Likes Received:
      7
      Trophy Points:
      18
      NoWorries on this issue anymore freshinstall fixed it BUT as i am doing the Shieldwall Quests i died an its not running back to corpse corpse is in the tunnel not sure its a quest issue or a HB
       
    15. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      HB issue. There is no pathing in the cave. Its all "click" movement. If you die here, or fall off track (move too far out of the way of the intended path) you must manually walk back. Also if you stop and start the bot here, you must restart it from the bottom of the stairs within the cave. Until I make the fix to auto walk from the entrance, this must be done, as only Ogudei's Lieutenants has the walk to code in.
       
    16. Madcatz

      Madcatz Member

      Joined:
      May 17, 2011
      Messages:
      752
      Likes Received:
      7
      Trophy Points:
      18
      ty for the damm fast response LOL was about to post my log LOL :)
       
    17. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, In2fun,

      Indeed Druid forms are a problem. There is no way for a profile to tell the CombatRoutine or Honorbuddy core not to use a form. If the profile actually cancels the form, its a race condition between the HBcore/CR putting the druid right back into that form versus the profile trying to get the necessary action issued.

      In short, this is not a profile issue, and the only work-around is to babysit Druids for quests like this. I run into this all the time, myself, and know that it is annoying. But, the HB architecture lacks a mature way to handle the problem at the moment.

      cheers,
      chinajade
       
    18. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Maxi155, and thanks for the log!

      It looks like your caches are corrupt. This is an Honorbuddy issue, not a profile problem. The remedy is below...

      If you want to help HBdev squish this bug once and for all:
      • Go to the HB/Cache directory and find the #######.cqc file(s)
      • Since the forum won't allow *.cqc to be directly uploaded, Zip the *.cqc files along with your log.
      • Upload the Zipped file to the Honorbuddy Bug Reports thread with a short description of the problem you encountered
      To get you going again, here's how to repair the cache issue:
      • Shut down WoW and Honorbuddy
      • Delete the WoW/Cache/, WoW/Data/Cache/, and Honorbuddy/Cache/ directories
      • Restart WoW and Honorbuddy
      Caches can get corrupted a few of ways:
      • You switch toons, or do a quick log out/in, without restarting Honorbuddy
      • You simultaneously run multiple sessions of Honorbuddy from the same directory on disk
      • There are other (user caused) triggers, but these are the most common.
      cheers,
      chinajade
       
    19. thebrodieman

      thebrodieman Well-Known Member Buddy Store Developer

      Joined:
      Sep 11, 2011
      Messages:
      6,015
      Likes Received:
      81
      Trophy Points:
      48
      Milestone Update:

      As it stands at this moment, there are approximately 27 quests remaining for me to program. Most of which are Dominance Offensive.
      I know there are a lot of glitches and bugs in the existing that are being worked out, but every bug report, every log file, and every patch uploaded is one step closer to perfection.

      Thank you for all the support, and my your rep bars and valor point caps fill at the fastest speed!
       
    20. LordNaomasa

      LordNaomasa New Member

      Joined:
      Jun 17, 2012
      Messages:
      18
      Likes Received:
      0
      Trophy Points:
      0
      Love this!!!! Been from 1-35 single night. This really is the ultimate profile/bot. I can't begin to imagine how much work you put into this. Absolutely incredible. And all the help on this thread is great too, especially from ChinaJade! Thanks more than you can imagine and keep it up.
       
      Last edited: Jan 15, 2013
    Thread Status:
    Not open for further replies.

    Share This Page