Hello, I have a problem with the new Honorbuddy release. When my warrior charges an NPC, sometimes (more often from higher range) HB clears the target and starts running towards another one saying that the target was tagged by someone else. My theory is that if the target is not tagged by anyone TaggedByMe returns false and it clears the target but I could be wrong.
It seems as if I temporary fixed it by activating "Sticky Targeting". However I don't think you need to be forced to activate it to use the bot. However if anyone else gets the same problem, activate "Sticky Targeting" until the developers can fix the problem.
Good to know I'm not alone with this problem. I'm using fresh install of HB with DWCC and Kicks questing profile. Running the bot alone. I've also tried with fresh install and Singular but still same problem. Yes, sticky targeting fixed to problem to an acceptable level where I can still run the bot without dying every 5 minutes.
i didnt say it was a solution, i just wanted to narrow it down. i did report it to our developers when i first made the post so they should be looking into it.
I've noticed that this happens on almost every pull. If you're being actively engaged, the bot clears the POI but then re-engages the target after taking damage. However, if your target is stunned (as is the case with my Rogue), when the POI is cleared by the bot, it causes the character to run off to the next target or hotspot, then when the stun ends and the character is attacked again, it re-engages. [Edit: Sticky targeting doesn't seem to fix the issue, for me] [Edit 2: Just observed a level 44 druid do exactly the same thing in Searing Gorge. Maimed the target, then ran off to skin my kill, then ran back when debuff ended. Seems quite pronounced for CR's that use stuns in the routine]
