• Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • Magitek - All in One

    Discussion in 'Combat Routines' started by Exmortem, Mar 28, 2014.

    Thread Status:
    Not open for further replies.
    1. papatoast

      papatoast Member

      Joined:
      Jan 15, 2010
      Messages:
      237
      Likes Received:
      0
      Trophy Points:
      16
      I've noticed on the 'All Basic' job setting (don't know about others as I haven't tried), that it will over-anticipate healing as ACN and CNJ.

      For example, it will cast cure and immediately start casing another before the first one has had a chance to land (and thus heal) the target, leading to a waste of mana and overhealing. All the log says is '[Magitek] Casting cure / DoAction Spell 120 0x1004CC1E', so not much to see there as to why.

      My game latency is about 120ms, so it shouldn't be having too much of an effect on things.
       
    2. Exmortem

      Exmortem Community Developer

      Joined:
      Mar 28, 2010
      Messages:
      799
      Likes Received:
      16
      Trophy Points:
      18
      Go into the healing manager settings and set the double cast timer to 2 or 3, it's a problem with the game not registering a heal fast enough. the double cast timer will try to compensate for it.
       
    3. kagamihiiragi17

      kagamihiiragi17 Community Developer

      Joined:
      Jun 24, 2014
      Messages:
      873
      Likes Received:
      25
      Trophy Points:
      0
      It's the same problem as the bot attempting to use items twice (like when your chocobo dies and it tries to resummon it, spamming gyshal greens forever, and sometimes it will use food twice because it decides to use food again because the buff hasn't kicked in yet).
       
    4. papatoast

      papatoast Member

      Joined:
      Jan 15, 2010
      Messages:
      237
      Likes Received:
      0
      Trophy Points:
      16
      Ok, on it. What's the setting's time value? Is it in milliseconds, seconds, etc?
       
    5. Klacid

      Klacid Member

      Joined:
      May 29, 2014
      Messages:
      173
      Likes Received:
      2
      Trophy Points:
      18
      I have a problem with Accept Raise, which is that it resurrects and gets stuck at the Aetheryte options if you don't accept one. Basically ->Dead->Returns to Aetheryte->Gets stuck in Aetheryte options (the same list as when you right-click it)
       
    6. kagamihiiragi17

      kagamihiiragi17 Community Developer

      Joined:
      Jun 24, 2014
      Messages:
      873
      Likes Received:
      25
      Trophy Points:
      0
      Do you normally play with a gamepad?
       
    7. Klacid

      Klacid Member

      Joined:
      May 29, 2014
      Messages:
      173
      Likes Received:
      2
      Trophy Points:
      18
      Nope, PC all the way.
       
    8. papatoast

      papatoast Member

      Joined:
      Jan 15, 2010
      Messages:
      237
      Likes Received:
      0
      Trophy Points:
      16
      I've raised the double cast timer to 10 so far (increasing by one per guildhest run) and it still double casts every time. Can I get some advice on how the setting is supposed to work?
       
    9. sparkiezz

      sparkiezz Member

      Joined:
      Apr 5, 2013
      Messages:
      132
      Likes Received:
      1
      Trophy Points:
      18
      Does anybody know a good dispel list?
       
    10. sparkiezz

      sparkiezz Member

      Joined:
      Apr 5, 2013
      Messages:
      132
      Likes Received:
      1
      Trophy Points:
      18

      Yeah same it doesn't work for me either, I even put 1000....
       
      Last edited: Jul 2, 2014
    11. papatoast

      papatoast Member

      Joined:
      Jan 15, 2010
      Messages:
      237
      Likes Received:
      0
      Trophy Points:
      16
    12. xioustic

      xioustic New Member

      Joined:
      Jan 5, 2013
      Messages:
      2
      Likes Received:
      0
      Trophy Points:
      0
      Hey guys,

      Have a Level 30 Monk. Have it set to Fate Bot. Didn't mess with any of the settings except for enabling Chocobo in Fate Bot and setting targeting to "Fate Mobs".

      I'm consistently getting this error message, which causes the bot to just sit still or run forward forever:
      This tends to happen immediately after a Mob is targeted.

      Using the latest SVN pull (rev 138).

      Any ideas?

      I found one instance in Monk.cs where the term "Boot Shine" was used, which must be a typo or error since the actual skill is called "Bootshine". I replaced/fixed that but this issue still persists.

      I don't get the same issue with the default Kupo profile.
       
    13. Exmortem

      Exmortem Community Developer

      Joined:
      Mar 28, 2010
      Messages:
      799
      Likes Received:
      16
      Trophy Points:
      18
      For the people having issues with the double casting healing timer? Are you guys using Basic Classes, cause I found an error Arcanist and Conjurer, but I can't explain why it wouldn't work with WhiteMage or Scholar. I updated the routine, please give it a try.
       
    14. Exmortem

      Exmortem Community Developer

      Joined:
      Mar 28, 2010
      Messages:
      799
      Likes Received:
      16
      Trophy Points:
      18
      xioustic, please download the new version and let me know if your issue is fixed.
       
    15. exaccuss

      exaccuss Active Member

      Joined:
      Nov 10, 2013
      Messages:
      1,021
      Likes Received:
      6
      Trophy Points:
      38
      with dragoon, is it possible to make heavy thrust not activate from the front and back of the target, as you only get the benefit from it from the flank only? Thanks.
       
    16. Exmortem

      Exmortem Community Developer

      Joined:
      Mar 28, 2010
      Messages:
      799
      Likes Received:
      16
      Trophy Points:
      18
      I thought you got it from any direction, but yeah. Updated on SVN.
       
      Last edited: Jul 2, 2014
    17. papatoast

      papatoast Member

      Joined:
      Jan 15, 2010
      Messages:
      237
      Likes Received:
      0
      Trophy Points:
      16
      Yes, sorry I should have specified. I was leveling ACN and CNJ both (alternating leveling). Haven't gotten to the point where I can use WHM or SCH yet.

      Thanks for the prompt fix :)
       
    18. Exmortem

      Exmortem Community Developer

      Joined:
      Mar 28, 2010
      Messages:
      799
      Likes Received:
      16
      Trophy Points:
      18
      So it's working now?
       
    19. papatoast

      papatoast Member

      Joined:
      Jan 15, 2010
      Messages:
      237
      Likes Received:
      0
      Trophy Points:
      16
      Yep, appears to. No more double casting physick.
       
    20. bmanley4051

      bmanley4051 New Member

      Joined:
      Sep 28, 2012
      Messages:
      10
      Likes Received:
      0
      Trophy Points:
      0
      I can't for the life of me figure out how to tab target or switch targets while tanking as a PLD. I'm new to Magitek, I apologize for such a trifling question.
       
    Thread Status:
    Not open for further replies.

    Share This Page