HB ARCHIVES: Honorbuddy Profile Pack--DO NOT DELETE!

I've seen this issue come up a few times in the past, not entirely sure what 'causes' it.

But if I had to guess, the bot is (somehow) falling off the boat.
With my testers, it seems to happen fairly rarely, not every time.

Once I get some testers out to that spot, I'll work in some failsafes that will make the bot 'properly' get back on the boat if it falls.
Thanks for the report and log!

 

The profiles support both ground and flying fully and are tested regularly with both.
What issues are you having?

 

Are you using the Tanaan Dailies profile?
If so, untick "Grind Saberstalkers" on the profile config menu.

 

Thanks for the tip! I'll keep an eye out for these details while testing.

 

Thanks! xD
No problem, good luck!

 

How long as it said 'Loading Profile...' ?
Sometimes it will take the bot a bit of time before loading the profile and you'll have to wait a bit as the bot is checking a few things before starting.

Do you perhaps have a log of this?

 

The log you see on Honorbuddy isn't as descriptive as the actual log that's being printed to your log folders.
So the ones in your log folders may be more informative as to what's going on.

Alternatively, you could always try a fresh install.
'Loading profile...' times have known to take some time in the past, but never longer than a minute.

 

A log is always helpful. But if you don't want to bother with posting one - try a fresh install.
If it still occurs during the fresh install - then a log would definitely be needed.

 

Yup.

From the looks of the log, the bot is downloading the Mesh files. See image: http://azyul.com/l/05-15-26.jpg
Downloading of the Mesh files can take anywhere from seconds to minutes - depending on how far the bot is travelling.

Unfortunately there's no 'message' on the bot that says when the Mesh files are being downloaded, so to a user it just looks as if the bot is standing around doing nothing.
Alternatively can set your "logging" level to Diagnostic on the "Settings & Tools" menu - which that will make it show on your Log that the Mesh files are being downloaded.

Since the Mesh files are being downloaded, you may just have to wait.
If 10minutes pass and it still isn't moving, then report here again.
In that case, the issue may be a new bug that we've never encountered before - in which you'll need to post into the "Support Section" so the other moderators can help you.