• Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic

    • Tab target

    Discussion in 'Honorbuddy Support' started by Matty_The_Keeper, Oct 3, 2016.

    Thread Status:
    Not open for further replies.
    1. Matty_The_Keeper

      Matty_The_Keeper New Member

      Joined:
      Oct 10, 2012
      Messages:
      250
      Likes Received:
      0
      Trophy Points:
      0
      Having an issue were when u use combat bot and u try to switch targets but it forces you to stay on one target till its dead just wondering if there is a way to change that up or is that just how u made combat bot this time around

      View attachment 5420 2016-10-02 20.38.txt

      There is a log for you
       
      Matty_The_Keeper, Oct 3, 2016
      #1
    2. Tony

      Tony "The Bee" Staff Member Moderator

      Joined:
      Jan 15, 2010
      Messages:
      128,834
      Likes Received:
      571
      Trophy Points:
      113
      check your CR settings about targeting plz
       
      Tony, Oct 3, 2016
      #2
    3. Matty_The_Keeper

      Matty_The_Keeper New Member

      Joined:
      Oct 10, 2012
      Messages:
      250
      Likes Received:
      0
      Trophy Points:
      0
      the targeting tab was set to auto do I put it to enable or to none?
       
      Matty_The_Keeper, Oct 3, 2016
      #3
    4. Tony

      Tony "The Bee" Staff Member Moderator

      Joined:
      Jan 15, 2010
      Messages:
      128,834
      Likes Received:
      571
      Trophy Points:
      113
      to none
       
      Tony, Oct 4, 2016
      #4
    5. Matty_The_Keeper

      Matty_The_Keeper New Member

      Joined:
      Oct 10, 2012
      Messages:
      250
      Likes Received:
      0
      Trophy Points:
      0
      Fixed thanks tony
       
      Matty_The_Keeper, Oct 4, 2016
      #5
    6. Tony

      Tony "The Bee" Staff Member Moderator

      Joined:
      Jan 15, 2010
      Messages:
      128,834
      Likes Received:
      571
      Trophy Points:
      113
      great,you're welcome!
       
      Tony, Oct 4, 2016
      #6
    Thread Status:
    Not open for further replies.

    Share This Page