• Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • ArchaeologyBuddy - An Archaeology Bot

    Discussion in 'Archives' started by raphus, Jan 20, 2011.

    Thread Status:
    Not open for further replies.
    1. daemon9

      daemon9 New Member

      Joined:
      Feb 11, 2011
      Messages:
      528
      Likes Received:
      5
      Trophy Points:
      0
      The left half of the Jintha'Alor digsite needs some serious work. I watch my toon dig around for one artifact for almost 20 minutes. He kept getting on his flying mount even tho his survey showed a green light. And instead of just walking over to the closest and most obvious dig spot, he flew down to another dig spot that was too far for a green light. Btw, I'm using Gathermate2 to see if he's following the same dig patterns.
       
    2. chemical

      chemical Active Member

      Joined:
      Aug 30, 2010
      Messages:
      1,310
      Likes Received:
      4
      Trophy Points:
      38
      Any one getting a" find buyer so and so"? To sell and buy from when your bags aren't even full? Sorry posting from phone can't remember vendors name

      Also I'm at 375 skill and have training off

      Sent from my SAMSUNG-SGH-I897 using Tapatalk
       
    3. XXMoonXX

      XXMoonXX New Member

      Joined:
      Mar 17, 2011
      Messages:
      8
      Likes Received:
      0
      Trophy Points:
      0
      Not sure if someone has already reported this but I've noticed when using Archaeology Bot when it is gathering the artifacts, sometimes if tablets or keystones etc are in the lootbox it doesn't loot it, nor the fragments that were with it. and it just mounts up and goes to head off to other other digsites.
      Not sure if this is of any help.
       
    4. Amplified

      Amplified Member

      Joined:
      Jan 15, 2010
      Messages:
      48
      Likes Received:
      0
      Trophy Points:
      6
      I need some help. I seem to be the only one having this problem. So it has to be something I am doing.

      My char does everything right in terms of archaeology. But when he enters combat after gaining aggro, he "Faces the Target". And then he just sits there getting beat on and does nothing. It does this with both Hawker Druid 2.5 CC (default HB one). And also Default Druid CC from FPS. So I have no idea how to get it to work. Any ideas. I'll post the part of the log below:

      The reason it goes to the next survey point is because I have to manually kill the target. Otherwords, it will sit there forever.
       
    5. buddyforum

      buddyforum New Member

      Joined:
      Mar 5, 2011
      Messages:
      80
      Likes Received:
      0
      Trophy Points:
      0
      I blacklist areas using this and the bot still goes there and hence dies (level 81 going to ULDUM)...

      any ideas on why?
       
    6. daemon9

      daemon9 New Member

      Joined:
      Feb 11, 2011
      Messages:
      528
      Likes Received:
      5
      Trophy Points:
      0
      New version, same old problem with the Nek'Mani Wellspring digsite:
       

      Attached Files:

    7. Nonamed

      Nonamed New Member

      Joined:
      Jan 15, 2011
      Messages:
      24
      Likes Received:
      0
      Trophy Points:
      0
      I blacklist areas using this and the bot still goes there and hence dies (level 81 going to ULDUM)...

      any ideas on why?

      If you got four of sites in Uldum, there's no possibility to stop him, except hands.
       
    8. daemon9

      daemon9 New Member

      Joined:
      Feb 11, 2011
      Messages:
      528
      Likes Received:
      5
      Trophy Points:
      0
      Got home, disconnected again...probably got stuck flying around in circles...or it was just rolling restarts:
       

      Attached Files:

    9. Mupp

      Mupp New Member

      Joined:
      May 3, 2010
      Messages:
      613
      Likes Received:
      5
      Trophy Points:
      0
      Hey Raph, there is a small issue at the Khintaset digsite in uldum. If the "find" is on the north side of the digsite the bot will mount up on the ground mount and head down the mountain on the south side. This is not a good idea because there is like 7 packs of human Archaeologiest there and each pack has 7 or 8 mobs. My char can beat about 6 but then he dies :)

      Dont know why it does that could be a mesh issue.
       
    10. aprisma

      aprisma New Member

      Joined:
      Feb 25, 2011
      Messages:
      359
      Likes Received:
      0
      Trophy Points:
      0
      Still stuck at ruins of solarsal:
      <Hotspot X="-5068.863" Y="3330.569" Z="71.61181" />

      and as usual the log file. This isle is really tricky :)))

      thanx for fix it ........
      cheers,
       

      Attached Files:

    11. daemon9

      daemon9 New Member

      Joined:
      Feb 11, 2011
      Messages:
      528
      Likes Received:
      5
      Trophy Points:
      0
      Flying in crazy circles in Plaguewood again, disconnecting WoW...
       

      Attached Files:

    12. aprisma

      aprisma New Member

      Joined:
      Feb 25, 2011
      Messages:
      359
      Likes Received:
      0
      Trophy Points:
      0
      Hello,

      do you disconnect yourself or do you have plugin? Disconnect would help a lot not to get caught when flying in circles.
      thanx,
      cheers,
       
    Thread Status:
    Not open for further replies.

    Share This Page