[Plugin - Ach/Pet] Higher Learning Achievment !

It's probably outdated now too.

And they have known about the meshing in dala for a good while now. Not sure if there is a poblem stopping them from doing it, or they was more worried about getting cata zones sorted.

 

Would be great if they did and the plugin got updated would be nice to get that achivment, iv never been arsed to try and get it myself

 

I got it to work again. Have i the allowance of the Autors to upload it here?

 

yes plx!

 

Heyho
I will take a another look at this Problem:

And then upload the fixed Plugin and Profile today evening .

 

Thx kaz, also there was massive dalaran mesh issue's that's why this plugin didnt work, Main Re-meshed dalaran but made it alot worse due to the bot being unable to navigate in houes etc... this was some time back so it could of been fixed by now.

 

So here is a Fixed Version and a fixed Profile

The only problems I noticed:
Sometimes he gets stucked for some seconds on a Mailbox (But this also happens to me, if I walk through Dala manuell ) But he always managed a fast unstuck.
And sometimes he dismounts without reason. I sadly don't find the trigger of this behavior.
It would be nice if this Version finds his way to the First Post , if its ok.

yours sincerely
katzerle

 

updated

 

TYVM Kaz, you made my day

 

TYVM I love collecting pets so this will help get my pet nr 127

 

Anyone already got the av?
Running plugin and profile this night an give it a try - thanks a lot mate

 

THANK YOU VERY MUCH ! =)

 

mesh in Dal is still rooted for me, I deleted the Northrend mesh directory, started up HB in Dal, loads new mesh, runs around and gets in area outside of VH and tries to run through the wall, same in the bank near the fishing trainer, just goes into corner and tries to run through the wall.

Anyone else having problems ?

G

 

probably needs this blackspot

<Blackspot X="5863.313" Y="638.0999" Z="647.2977" Radius="10" />

mailbox at ledgerman lounge

G

 

Exact same issue here

 

ran it today, seemed to run a little better, was only getting caught on the mailbox, not sure what the difference is. Just make sure you run the .xml in GB2 mode.

G

 

Use the profile linked in 1st post! Had nearly no issues and got my achievement -> Post #152 in this topic btw...

 

Testing now, will report back.

 

hey. .. ive just tryed to use your profile ... but it didnt work that well because every time he gets out of the inn he gets stuck at the mailbox that ive already blacklisted ... after a second running against it he loggs out ... and this every time , that means every 3-4 mins ... need some help , otherwise i will have to log in , restart HB etc. every time ;/

 

Alas, this isn't a profile problem, but an HBcore problem (specifically, the meshing).

As you've discovered, blackspots frequently don't work (especially in flat areas). This Wiki article may provide some insight as to why...

[wiki]Profile Writing: About meshes, navigation, and blackspots[/wiki]​

As the article demonstrates, you can blackspot a much larger area than the area in which you place your blackspot. If the area is too large, the blackspot is ineffective because there are no other significant paths through the area without going through the blackspot.

Basically, you need to include the exact X/Y/Z location and a screenshot, and ask for the area to be remeshed. There is a "Mesh issues here" post somewhere, or you can use BugTracker.



cheers,
chinajade