Hi guys, So, when running ArchaeologyBuddy in Draenor, it seems to work fine until the markers turn green. Once you get green markers indicating that you are close to a fragment, it just digs in the same spot two more times and then mounts up and runs away. This process simply repeats endlessly. Leaving the bot to run results in 0 recovered fragments. I have performed a clean install and have attempted to run this using the unmodified [Warrior] Singular v4.0.0.3920 routine. This issue occurs in any archaeology zone in Draenor. Logs have been attached for your convenience. Any help with this would be very much appreciated. If you need any other info, please let me know. Thanks in advance guys.
Hi guys, So is no one else having this problem? Please let me know as if its working fine for everyone else, I would be tempted to test this on another computer completely just in case. Please let me know. Thanks again
Not sure if this helps but, I have tested this again on a completely independent computer and its the same issue. I think its an issue with the bot. Surprised no one else has reported it to be honest
arecheology support for WoD Content is still being worked on. right now its the same logic as it was Pre WoD in those zones so its going to take time for our devs to go in and update the bot for use in those zones.
Hi CodenameG, thanks for the update on this. Good to know its on the to do list, wasn't sure if it was just me or not as couldn't find any other thread on the matter. Thanks again mate
