• Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic

    • [Warning] Line 6: Unknown attribute 'TargetMinLevel'

    Discussion in 'Archives' started by pashadiv, Jun 7, 2011.

    Thread Status:
    Not open for further replies.
    1. pashadiv

      pashadiv New Member

      Joined:
      Jan 15, 2010
      Messages:
      81
      Likes Received:
      0
      Trophy Points:
      0
      Getting some Red on my newer meshs
      [23:41:34.489 N] [Warning] Line 6: Unknown attribute 'TargetMinLevel'
      [23:41:34.489 N] [Warning] Line 6: Unknown attribute 'TargetMaxLevel'

      i whent into the Main Profile and tryed editing Line 6 TargetMinLevel changed to 40 and set max to 51 but same thing ;(
       
      pashadiv, Jun 7, 2011
      #1
    2. socialscience

      socialscience New Member

      Joined:
      May 29, 2011
      Messages:
      85
      Likes Received:
      0
      Trophy Points:
      0
      Actually I took that part out of mine and it worked fine.
       
      socialscience, Jun 7, 2011
      #2
    3. pashadiv

      pashadiv New Member

      Joined:
      Jan 15, 2010
      Messages:
      81
      Likes Received:
      0
      Trophy Points:
      0
      i dont think thats the problem as most the paths are set to finsh @ 51 but ill try

      *EDIT*

      ya that didnt do anything ;)
       
      pashadiv, Jun 7, 2011
      #3
    4. limjampley

      limjampley New Member

      Joined:
      Jun 8, 2011
      Messages:
      7
      Likes Received:
      0
      Trophy Points:
      0
      ya i simply removed the part of the line mentioning minlevel/maxlevel and it doesnt give error now for me. i did however erase a closing bracket on the line and messed me up for a good while.lol
       
      limjampley, Jun 9, 2011
      #4
    5. MaiN

      MaiN Moderator Staff Member Moderator Buddy Core Dev

      Joined:
      Jan 15, 2010
      Messages:
      1,017
      Likes Received:
      35
      Trophy Points:
      48
      In case the Warning tag was not clear enough, this is not an error, but a warning. It doesn't make a difference if you leave it there or not. The attribute will most likely be introduced in the next release again.
       
      MaiN, Jun 9, 2011
      #5
    Thread Status:
    Not open for further replies.

    Share This Page