I started experiencing issues by which HB could not find paths in Pandaria. Did a clean install of HB and deleted all mesh folders but the issue is still prevailing. All other areas of WoW seem to find paths fine bar Pandaria. Log attached. On an interesting note, further investigation shows that if GB2 is started with a valid node near by it navigates to that ok. But following a profile path fails. Tested on multiple profiles now all with the same outcome. Edit: Ghost walking seems to pull down the meshes and navigate fine.
Oops, sent a log from a Stop & Start. New log attached. This log actually shows my initial point that if a node is nearby HB will nav to it but not path.
First Log was the release. But please find attached Log for latest HB version. very strange it's only pandaria.
All the time, but only in Pandaria. Yep cleared mesh several times, re-install .net framework the lot.
can you try this one plz? http://www.thebuddyforum.com/honorb...le-zone-herbalism-mining-re-made-updated.html also set a flying mount on Hb settings
Strange, now that profile works. But PB 1-600 doesnt. Edit: Tell a lie, it works for a bit then gives up.
I think we have (the) same problem http://www.thebuddyforum.com/honorb...s/98140-could-not-generate-path-pandaria.html
The toon is level 90 but doesn't have the skill yet. Maybe that is the issue, but I have tried with ground profiles Sent from my 7 Trophy using Board Express
So the not doesn't use a ground mount on a ground profile, if the toon is 90? Sent from my 7 Trophy using Board Express