• Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • HB ARCHIVES: Honorbuddy Profile Pack--DO NOT DELETE!

    Discussion in 'Archives' started by chinajade, Sep 8, 2013.

    1. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Tigerlady3012, and thank you for the log.

      The The Eyes of Grillok - Quest - World of Warcraft quest can take a while to complete, just be patient.

      • The Eyes of Grillok are not plentiful
      • The toon must use the item before it is "spotted" by the eye
      • You don't always get the required aura to complete the quest when the item is used

      cheers,
      chinajade


      [size=-2]Ref: Tigerlady3012's original post w/log[/size]
       
    2. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Ambrose, and many thanks for the logs.

      [00:27:28.765 D] System.Reflection.TargetInvocationException: Exception has been thrown by the target of an invocation. ---> System.Exception: Process must have frozen or gotten out of sync: InjectionFinishedEvent_was_never_fired
      at GreyMagic.Executor.WaitForInjection(Int32 timeout)​

      The remedy for "GreyMagic" errors is usually to reboot the machine.

      If no joy, please post your logs to the Support forum, as the problem is obviously not profile-related.

      cheers,
      chinajade


      [size=-2]Ref: Ambrose's original post w/log[/size]
       
    3. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Very clever solution, MaxMuster!

      Your changes have been folded into v3061.

      I recall that the golem counts as a "minipet". Thus, you are probably right about it being a Unit() instead of an Object(). But, I'm not going to mess with a blind fix on tested code.

      We've dropped some comments into the profile. The next time we're through the area, we'll look at changing Object() to Unit(), and qualifying it further with a creator Id, or the range check you suggested.

      cheers & thank again!
      chinajade


      [size=-2]Ref: MaxMuster's problem report w/recommended repair[/size]
       
    4. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      <waves at MaxMuster>,

      Repaired in v3062.

      cheers,
      chinajade


      [size=-2]Ref: MaxMuster's problem report w/repair[/size]
       
    5. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
    6. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Thanks, MaxMuster!

      We've folded both of these repairs into v3064.

      cheers,
      chinajade


      [size=-2]Ref: MaxMuster's recommended repair #1[/size]
      [size=-2]Ref: MaxMuster's recommended repair #2[/size]
       
    7. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
    8. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Dna9418,

      Highvoltz worked through those profiles not long ago, and they were very smooth after he got done. My guess is you are having problems with an interfering addon or plugin, or somesuch. The only way to tell is to show us a log.

      cheers,
      chinajade
       
    9. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Hoper,

      From the log, Honorbuddy doesn't run very long after the profile gives it the directive to collect red crystals. The red crystals are in the southwest part of Un'goro, which is a very dangerous area, indeed. The log shows you crossing paths with a Devilsaur on the way to the area, and then terminates shortly thereafter. From the log, the only conclusion I can draw is one of impatience. (No offense intended).

      In v3066, I've made a very minor change to the profile. I don't believe it will solve your problem, however.

      If you wish to hurry this along, then do the Crystals of Power - Quest - World of Warcraft quest manually, turn it in, then start Honorbuddy again.

      cheers,
      chinajade


      [size=-2]Ref: Hoper's original post w/log[/size]
       
    10. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, MaxMuster,

      Thanks for the tuning of "Axe of Earthly Sundering". This seems to be the quest that just won't ever solve smoothly. Your refinements have been folded into v3067.

      cheers,
      chinajade


      [size=-2]Ref: MaxMuster's refinement post[/size]
       
    11. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
    12. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
    13. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Hoper and many thanks for the log!

      [13:31:57.690 D] [InteractWith-v1188(debug)] Attempting use of 'Stonefather's Banner' on 'Stonehearth Defender' (health: 83.2)
      [13:31:57.723 D] [Lua.Events] Attached to event UNIT_SPELLCAST_FAILED with handler HandleInterrupted
      [13:31:57.755 D] [Lua.Events] Attached to event UNIT_SPELLCAST_INTERRUPTED with handler HandleInterrupted
      [13:31:57.789 D] (Singular) [CombatLog] SPELL_CAST_FAILED Stonefather's Boon: Stonefather's Banner - Cover#80670 failure: 'You are mounted.'

      The problem should now be repaired in v3070, and thanks for bringing it to our attention.

      On another note...
      This is going to cause you problems eventually. You should set the "Mount" to a genuine ground-only mount, and not a flying mount:
      * Ground mount (Tawny Wind Rider) is a flying mount. Please configure a ground-only mount.

      cheers,
      chinajade


      [size=-2]Ref: Hoper's problem report w/log[/size]
       
    14. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, MaxMuster,

      v3071 repairs the quest for both the Alliance and the Horde side. We left the WaitTimer outside the <If> where you recommended, but are a little concerned this will make the profile start-stop unfriendly.

      cheers,
      chinajade


      [size=-2]Ref: MaxMuster's problem report w/recommended repair[/size]
       
    15. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, MaxMuster,

      The MoveTo is a band-aid for #HB-332 ("<Objective > needs to be more focused on its task"). The band-aid will work, unless Honorbuddy needs to do a vendor run or such. This is why we prefer not to apply band-aids, but to address the underlying problems in Honorbuddy.

      In any case...
      we've folded the (much appreciated) recommendation into v3072 to facilitate the user experience. The changes have been folded into both the Alliance and the Horde profiles.


      cheers,
      chinajade


      [size=-2]Ref: MaxMuster's problem report w/recommended repair[/size]
       
    16. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
    17. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, BestPlox, and thank you for the log.

      The quest?The Eastern Pylon - Quest - World of Warcraft offered by Ithis Moonwarden - NPC - World of Warcraft? is very much alive and well. Your log provides no clue as to the problem, because Honorbuddy was stopped on the way to the quest-giver.

      [23:55:39.506 N] Moving to Type: QuestPickUp
      [23:56:35.868 N] Stopping the bot!
      [23:56:35.868 Q] Bot stopping! Reason: User pressed the stop button

      In short, we've no way to help you with this information, as from your log, it looks like Honorbuddy is doing the right thing.

      You might try clearing your caches and see if that is the problem. This article will help you through that process:


      cheers,
      chinajade


      [size=-2]Ref: Bestplox's original post w/log[/size]
       
    18. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Rubberduckofhell,

      Somehow, your quest state has become damaged. In v3074, we've put in a defensive check to account for this.

      You will also probably want to make certain your caches are clean. This article will assist you with that:

      cheers,
      chinajade


      [size=-2]Ref: Rubberduckofhell's original post w/log[/size]
       
    19. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Ruffian,

      There is absolutely no chance of helping you with problems like this, unless you attach the full log that captures the issue.

      cheers,
      chinajade
       
    20. chinajade

      chinajade Well-Known Member Moderator Buddy Core Dev

      Joined:
      Jul 20, 2010
      Messages:
      17,540
      Likes Received:
      172
      Trophy Points:
      63
      Hi, Tokinterrorz,

      You are bumping into an issue with the PickUp for the "Loss Reduction" quest. That problem was solved in v3058.

      If you'll update your profiles, you should be golden.

      cheers,
      chinajade


      [size=-2]Ref: Tokinterrorz' problem report w/log[/size]
       

    Share This Page