• Visit Rebornbuddy
  • Visit Panda Profiles
  • Visit LLamamMagic
  • ShamWOW for HB - All Shaman Specs for Solo+Dungeons+Raids+PVP by Bobby53

    Discussion in 'Archives' started by bobby53, Sep 13, 2012.

    Thread Status:
    Not open for further replies.
    1. encarsia

      encarsia New Member

      Joined:
      Apr 20, 2011
      Messages:
      66
      Likes Received:
      0
      Trophy Points:
      0
      the enhance profile doesn't even auto attack while it casts unleash or shocks or totems or wolves. theres literally just 4+ seconds of it standing there getting attacked by a mob.
       
    2. rob-man

      rob-man New Member

      Joined:
      Mar 17, 2012
      Messages:
      223
      Likes Received:
      0
      Trophy Points:
      0
      Which talents and glyphs should i choose as an elemental shaman using this cc?
       
    3. Hasp

      Hasp New Member

      Joined:
      Apr 2, 2010
      Messages:
      69
      Likes Received:
      2
      Trophy Points:
      0
      Enhancement seems to have some targeting problems. I had to stop the bot because it was dying too much from just standing there.

      HonorBuddy Mode: Quest
      Shamans Location: Jade Forest
      What should have happened (be specific): Choose a target and kill it
      What did happen (be specific): Sometimes a target is chosen and sometimes it just stands there with no target. When it does choose a target but do nothing it keeps spinning around seemingly trying to face the target and can't figure out if it is or not. When it has no target it just stands and dies to mobs hitting it. The no target seems to happen the most when mobs aggro with the bot already in combat. Multiple mobs in close proximity cause it the most problems even if they aren't aggro'd.
      Computer time of problem or log mark (not realm time): Entire log. There was no specific time as it happens constantly while running the bot.
       

      Attached Files:

      Last edited: Oct 28, 2012
    4. akisf

      akisf New Member

      Joined:
      Jan 15, 2010
      Messages:
      24
      Likes Received:
      2
      Trophy Points:
      0
      Same conditions, enhacement shaman
      Also when it targets a mob it moves to it and it pass it for 2 yards then it wont turn to face mob and start combat.
      Same if you agro a mob while moving entering combat wont turn and face it.

      thank you,

      ps. will provide log in next session
       
    5. Scavanger

      Scavanger New Member

      Joined:
      Sep 19, 2012
      Messages:
      182
      Likes Received:
      0
      Trophy Points:
      0
      Im no expert at reading logs or coding or anything to that nature, but my shaman has 456 ilvl gear and should not be dropping as low on health as he does when botting, I know because Ive done the area in less gear easier. Hes not casting elemental mastery, healing tide totem should come out at any fight to help sustain higher health regen, and this may be on me in some setting somewhere, but there is delays in between spell casting, enough to where i can manually hit my healing tide totem or something to help out.
      View attachment 3764 2012-10-29 01.29.zip
       
    6. hbaioni

      hbaioni New Member

      Joined:
      Oct 17, 2011
      Messages:
      299
      Likes Received:
      1
      Trophy Points:
      0
      Hey Bobby, some questions for you:
      1) The other day, in a raid environment, the raid leader asked me to "SWITCH" mi earth shield to the tank who had the aggro at a given time... I told him "YES YES" (lol). The thing is, i haven't found a way to disable earth shield. Is there a way to prevent ShamWoW to cast it, so I can cast is manually?
      2) I'm not quite comfortable with the Ascendance setting. ShamWoW casts it too frequently, i would like to save it for more dangerous situations. I haven't found its setting in the UI. Is there a way to change the HP% that is needs to activate?
      3) In a prior post you said that 4.0.7 version supports HEALING STREAM and HEALING TIDE totem, buy i haven't found the settings for these two spells. (Moreover, the toon is not casting them, but this can happen for a vast number of reasons). So, where I can set them up?
      Thanks in advance.
       
      Last edited: Oct 29, 2012
    7. honorbr

      honorbr New Member

      Joined:
      Apr 4, 2012
      Messages:
      28
      Likes Received:
      0
      Trophy Points:
      0
      Elemental Shaman - Elemental Blast

      Hello, the rotation of the elemental shaman spell Elemental Blast (Elemental Blast - Spell - World of Warcraft) is not included! It is purposeful or need to configure something for her to be included? thank you
       
    8. ez101

      ez101 New Member

      Joined:
      May 20, 2012
      Messages:
      249
      Likes Received:
      0
      Trophy Points:
      0
      1. The CC seems to not self defend in certain situations. For example, in Zouhcin Strand (at the coastline, the Blackmane Trackers have wolves as pets. When the mob is dead still attacks, but no self defense. Also, in Dread wastes, same thing with the packs of small wasps. Log attached. Name of mob in Dread Wastes is Waste Scavenger.

      2. I keep getting error messages about the percentages for shields. Even when I correct them. Isn't there a way to select just one shield and be done with it? For example, I'd rather have water shield full time due to low mana at level 88.
       

      Attached Files:

    9. daekas

      daekas New Member

      Joined:
      Oct 22, 2012
      Messages:
      6
      Likes Received:
      0
      Trophy Points:
      0
      Availiable for mop version?
       
    10. Woxenrud

      Woxenrud New Member

      Joined:
      Apr 16, 2012
      Messages:
      13
      Likes Received:
      0
      Trophy Points:
      0
      I too would like a fix for this.
      He also uses earth shock before stormstrike for some reason
       
    11. EmillimE

      EmillimE New Member

      Joined:
      Oct 31, 2012
      Messages:
      25
      Likes Received:
      0
      Trophy Points:
      0
      When elemental gets over 3 mobs on him, he just summons a fire elemental and waits it to kill him. If there isnt fire elemental available, then he just AFk and dies.

      Also, can you make it able to use healing totems?

      Ty
       
    12. gorunn

      gorunn Member

      Joined:
      Oct 26, 2012
      Messages:
      197
      Likes Received:
      1
      Trophy Points:
      18
      [Quest Bot (Kick's Questing Profile), Lazy Raider, Combat Bot]

      Same, im sure that this is not so much helpful without log, but i run on following issues.


      1. Pulling non aggroed hostile target:
      What is happening-
      If character is moving from point A to point B and there is a close hostile target in his way which IS NOT AGGROED, CC will dismount, move to target and pull it with "Unleash Elements" attack.
      What should happen -
      Nothing, shaman should keep moving on to point B.

      2. Issue with dropping Elementals:
      What does happen -
      If flame or earth elemental totems are dropped, character will just stand there and do nothing, Which result in his death when both elementals expire/die.
      What should happen -
      Shaman should keep attacking mob with who is in combat.

      3. Issue with newly joined mob in ongoing fight:
      What does happen -
      If character is already in combat and additional hostile mob joins the fight, after killing mob/mobs in initial pull character will just stand there, again, leaving him open to target that just joined the fight, to die.
      What should happen -
      Shaman should keep fighting. CC routine should effectively detect mob that is joined the fight and keep fighting.

      4. Issue with "Save cooldowns for stressful fights"
      What does happen -
      Even so i disabled Bloodlust, Elementals and Wolfs on stressful fights, and checked them to save them for boss fights, CC will use them anyway on a mob that i one level higher than me.
      What should happen -
      Shaman should not drop these cooldowns as per settings in CC.

      5. Talents which are new spells to spellbook are not detected:
      What does happen -
      Healing tide totem, Astral Shift and Stone Bulwark Totem are not dropped/used at all.
      What should happen -
      They should be detected and used by CC and shaman. Its good to add them as a option in "stressful fights" since they are good cooldown. Me, personally, prefer more Healing Tide totem + Wolf's + Ascendance/Astral Shift/Stone Bulwark Totem in stressful fights than popping my elementals, they are really big, shinny and they draw to much attention.

      5b. I got a little further and tested all talents that are spells on cast, for instance "Earthgrab Totem" which is new spell with its CD and all of them are not detected nor used. Its also nice to have them added in rotation, specially in "stressful fights"

      6. Wrong rotation in CC:
      What does happen -
      CC uses earth shock before stormstrike, it should be other way arround so shock would benefit from stormstrike debuff on target.
      What should happen -
      Stormstrike should be used before Earth Shock since Stormstrike increase next earth spell damage.

      Correct rotation with Glyph of Flame Shock (which is mandatory for Enhance shamans) is:
      Unleash Elements,Flame Shock,Stormstrike,Earth Shock,Stormstrike,Earth Shock,Unleash Elements,Stormstrike,Earth Shock,Stormstrike;
      Filing in with Lava Lash with 5 stacks of Searing Flames buff and Lighting Bolt with 5 stacks of Maelstrom weapon.

      I have checked logs and monitor rotation during combat, as per log, everything is working as it should be, but i will update this once more when i have log ready.
       
      Last edited: Nov 2, 2012
    13. greaterdeath

      greaterdeath New Member

      Joined:
      Apr 2, 2010
      Messages:
      815
      Likes Received:
      2
      Trophy Points:
      0
      From first page:
      1. How to post a question, issue, or constructive criticism ....
      Use the following steps when posting about ShamWOW. Always attach a complete diagnostic (debug) log file. For details on the HonorBuddy Setting required to create one of those, see FAQ #20 below.

      If info is missing, you will receive a standard reply requesting the missing information, which will add one to two days additional time to how long it takes for you to get assistance.
      Steps for Posting an Issue, Criticism, or Question...
      1. In this thread, click Reply
      2. When the Quick Reply window is shown, click the Go Advanced button.
      3. Copy and paste the following template into your post and fill in the blanks:
      HonorBuddy Mode: Grind/PVP/Mixed/Quest/RaF
      Shamans Location:
      What should have happened (be specific):
      What did happen (be specific):
      Computer time of problem or log mark (not realm time):
      4. Scroll down the page and click Manage Attachments
      5. Attach the most recent file from your HonorBuddy LOGS folder
      6. If the file is too large, you need to compress as .ZIP first then repeat Step 5
      7. Click the Close this Window button in Manage Attachments
      8. Click the Submit Reply button to post
       
    14. tanro

      tanro New Member

      Joined:
      Jun 27, 2012
      Messages:
      144
      Likes Received:
      0
      Trophy Points:
      0
      Playing an ele shaman. Goes into melee range and use totems. How do I change the pull distance on this CC?
       
    15. Exokid7699

      Exokid7699 New Member

      Joined:
      Jul 31, 2011
      Messages:
      193
      Likes Received:
      3
      Trophy Points:
      0
      I keep getting this message when i start honorbuddy with the cc

      ERROR: Could not add combat log event filter! - Performance may be horrible, and things may not work properly! no idea what this is lol

      Fixed it. Did a clean install of hb and shamwow. Hopefully it doesnt stop casting in the middle of fights now ;)
       
      Last edited: Oct 31, 2012
    16. gorunn

      gorunn Member

      Joined:
      Oct 26, 2012
      Messages:
      197
      Likes Received:
      1
      Trophy Points:
      18
      Previous post updated.

      Updated my previous post with more info, as you instructed. I will update it once more with log later. Ty for correction, i hope that my post is now more helpful and informative. ;)
       
    17. HBfanboy1980

      HBfanboy1980 Active Member

      Joined:
      Jan 16, 2012
      Messages:
      1,139
      Likes Received:
      11
      Trophy Points:
      38
      facing issues all of a sudden :/
       
    18. Hasp

      Hasp New Member

      Joined:
      Apr 2, 2010
      Messages:
      69
      Likes Received:
      2
      Trophy Points:
      0
      Is Bobby MIA or something? It's been quite a while since he's posted on this thread with any kind of response.
       
    19. X-Ploit

      X-Ploit Member

      Joined:
      Feb 24, 2012
      Messages:
      109
      Likes Received:
      0
      Trophy Points:
      16
      anyone got any good RAID ele setups..

      how do i stop it from casting hero/lust and during trash it pops fire ele totem. need to stop this.

      also during hero it pops acendance and then does nothing
       
    20. bfxr6

      bfxr6 New Member

      Joined:
      Jan 6, 2012
      Messages:
      62
      Likes Received:
      0
      Trophy Points:
      0
      Is there a way to stop recalling totems? For example, defending a base in AB i drop searing, totems get recalled as im not in combat, i get sapped and loose the base. Would you be able to add an option to stop recalling the totems?

      Also cannot choose what % i cast riptide @, any reason for this?
       
      Last edited: Nov 4, 2012
    Thread Status:
    Not open for further replies.

    Share This Page